BLJMJ - 20XX SERIES COLORS-B32
- MSDS: BLJMJ
- Manufacturer: CALIFORNIA PRODUCTS CORP
- Product Name: 20XX SERIES COLORS-B32
- National Stock Number: 8010-01-082-3061
Product Identification
Product ID:20XX SERIES COLORS-B32
MSDS Date:09/17/1986
FSC:8010
NIIN:01-082-3061
MSDS Number: BLJMJ
Responsible Party
CAMBRIDGE, MA 02139-4246
US
Emergency Phone: 617-887-5926/CHEMTREC 800-424-9300
Info Phone: 617-547-5300, EXT.208/617-547-5300
Cage: 08750
Contractor
Telephone: 617-547-5300 EXT 208
Cage: 08750
Ingredients
ETHYLENE GLYCOL (SARA III)
CAS: 107-21-1
RTECS: KW2975000
OSHA PEL C 50 PPM
ACGIH TLV: C 50 PPM,VAPOR; 9192
EPA Report Quantity: 1 LB
DOT Report Quantity: 1 LB
Hazards
LD50 LC50 Mixture:ETHYLENE GLYCOL ORAL LD50(RAT)=8.54 G/KG
Routes of Entry: Inhalation:NO Skin:NO Ingestion:NO
Reports of Carcinogenicity:NTP:NO IARC:NO OSHA:NO
Health Hazards Acute and Chronic:INHALE:VAPORS OR MISTS MAY BE SLIGHTLY
IRRITATING TO EYES, NOSE, THROAT & MUCOUS MEMBRANES OF RESPIRATORY
TRACT PRODUCING SYMPTOMS OF HEADACHE, NAUSEA IN POORLY VENTED AREA.
SKIN CONTACT:PROLONGED OR REPEATED CONTACT WITH COATING MAY
CAUSESLIGHT SKIN IRRITATION. DIRECT EYE CONTACT:INCONSEQUENTIAL EYE
IRRITATION.
Effects of Overexposure:INHALE:VAPORS OR MISTS MAY BE SLIGHTLY
IRRITATING TO EYES, NOSE, THROAT & MUCOUS MEMBRANES OF RESPIRATORY
TRACT PRODUCING SYMPTOMS OF HEADACHE, NAUSEA IN POORLY VENTED AREA.
SKIN CONTACT:PROLONGED OR REPEATED CONTACT WITH COATING MAY
CAUSESLIGHT SKIN IRRITATION. DIRECT EYE CONTACT:INCONSEQUENTIAL EYE
IRRITATION.
First Aid
First Aid:EYE & SKIN CONTACT:IMMEDIATELY FLUSH EYES WITH PLENTY OF
WATER FOR AT LEAST 15 MINUTES & CONSULT PHYSICIAN. WASH SKIN
THOROUGHLY WITH SOAP & WATER. IF DRENCHED, REMOVE & WASH CLOTHING
BEFORE REUSE. IN GESTION:IF VICTIM IS CONSCIOUS, GIVE 2 GLASSES OF
WATER & CALL A PHYSICIAN.
Fire Fighting
Flash Point:NONE
Accidental Release
Spill Release Procedures:KEEP UNNECESSARY PEOPLE AWAY. DIKE & CONTAIN
SPILL W/INERT MATERIAL(SAND,EARTH,ETC)& TRANSFER LIQ TO CONTAINERS
FOR RECOVERY OR DISPOSAL. KEEP SPILL OUT OF SEWERS & OPEN BODIES OF
WATER. FLOORS MAY BE SLIPPERY, CARE SHOULD BE EXERCISED TO AVOID
FALLS
Handling
Handling and Storage Precautions:MAX. STORAGE TEMPERATURE 140F, MINIMUM
34F. KEEP CLOSURE TIGHT & CONTAINER UPRIGHT TO PREVENT LEAKAGE.
PRECAUTIONARY LABELING "KEEP FROM FREEZING".
Other Precautions:DO NOT GET IN EYES. AVOID SKIN CONTACT. PREVENT
PROLONGED OR REPEATED BREATHING OF VAPOR OR MISTS. DO NOT HANDLE
UNTIL THE MANUFACTURER'S SAFETY PRECAUTIONS & LABEL INSTRUCTIONS
HAVE BEEN READ & UNDER STOOD. AVOID BREATHING SANDING DUST.
Exposure Controls
Respiratory Protection:USE APPROVED CHEMICAL/MECHANICAL FILTERS
DESIGNED TO REMOVE PARTICULATES IN OPEN & RESTRICTED VENTILATION
AREAS. USE APPROVED AIRLINE TYPE RESPIRATOR OR HOODS IN CONFINED
AREAS.
Ventilation:SUFFICIENT VENTILATION IN VOLUME & PATTERN TO KEEP AIR
CONTAMINANT CONCENTRATION BELOW APPLICABLE EXPOSURE LIMITS.
Protective Gloves:USE NEOPRENE OR RUBBER GLOVES
Eye Protection:SIDE & FACE SHIELDS, CHEMICAL GOGGLES
Other Protective Equipment:DISPOSABLE OR IMPERVIOUS CLOTHES IF WORK
CLOTHING CONTAMINATION IS LIKELY. USE PROTECTIVE CREAM IF SKIN
CONTACT LIKELY.
Work Hygienic Practices:WASH HANDS BEFORE EATING,SMOKING,USING WASH
ROOM. FOOD/BEVERAGE SHOULD NOT BE CONSUMED WHERE PRODUCT IS
HANDLED/STORED
Supplemental Safety and Health
NOTE: THIS PRODUCT ALSO CONTAINS TITANIUM DIOXIDE, CALCIUM CARBONATE,
KAOLIN OR OTHER PIGMENTS CLASSED BY ACGIH AS "NUISANCE DUST".
EXPOSURES TO SPRAY MISTS OR SANDING DUST SHOULD BE CONTROLLED TO
BEL OW 10 MG/M3 THROUGH USAGE OF NIOSH-APPROVED DUST FILTER
RESPIRATORS.
Chemical Properties
Boiling Pt:B.P. Text:212F,100C
Melt/Freeze Pt:M.P/F.P Text:32.0F,0.0C
Vapor Pres:760 @ 100C
Vapor Density:> THAN AIR
Spec Gravity:10 LB/GAL
Evaporation Rate & Reference:SLOWER (BUTYL ACETATE=1)
Solubility in Water:COMPLETE
Appearance and Odor:VISCOUS LIQUID SLIGHT AMMONIACAL ODOR.
Stability
Stability Indicator/Materials to Avoid:YES
STRONG OXIDIZING AGENTS (E.G., NITRIC ACID, PERMANAGANATES), ETC.
Hazardous Decomposition Products:SOME CARBON MONOXIDE.
Disposal
Waste Disposal Methods:THE COATING & ANY CONTAMINATED DIKING MATERIAL
SHOULD BE ALLOWED TO THOROUGHLY AIR DRY & COLLECTED INTO SEALED
DRUMS & PROPERLY LABELED WITH WASTE DESIGNATION & DISPOSED OF IN
ACCORDANCE WITH CURRENT LOCAL, STATE & FEDERAL REGULATIONS.
Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.